Search found 76 matches
- Sat Apr 12, 2014 11:40 pm
- Forum: General Discussion
- Topic: Changing Filament Mid Print?
- Replies: 15
- Views: 23004
Changing Filament Mid Print?
My son made a simple item that has lettering on it. It printed fine but he was asking me if the letters could be printed a different color. Is there a way to do this? I have read a few posts else where but they were using a Makerbot, they were saying there firmware will move the hot end away when pa...
- Sat Apr 12, 2014 11:34 pm
- Forum: Tech Support
- Topic: Problem with extruder
- Replies: 8
- Views: 11982
Re: Problem with extruder
I got it to work. I think something was bound up in there. I clicked retraction a few times and started to hear a click. Then I tried extrusion and the filament fed its way in there. Doing a test print now to see if it works ok.
Thanks
Thanks
- Sat Apr 12, 2014 11:03 pm
- Forum: Tech Support
- Topic: Problem with extruder
- Replies: 8
- Views: 11982
Re: Problem with extruder
Yes it is heating up but wont grab or even try. I think some may have gotten jammed in there. I think I can see some filament when I look down the feed hole but that may just be the remaining portion of what was there.
- Sat Apr 12, 2014 10:27 pm
- Forum: Tech Support
- Topic: Problem with extruder
- Replies: 8
- Views: 11982
Problem with extruder
Well I was just bragging about how well everything was working and bam have a problem. I retracted one color and everything seemed fine. When I went to put in the other it does not grab it or make any noise when I hit extrude. So I am basically dead in the water. Any suggestions?
Tracks
I have printed quite a few things and am happy to say my new M2 is working great. I have noticed that the prints seem to have lines across them were a small amount of material has oozed out while the hotend was traveling from a finish point to a new start point. Is there a setting that I can adjust ...
- Fri Apr 11, 2014 3:03 am
- Forum: Software
- Topic: Default M2 Settings
- Replies: 2
- Views: 7904
Default M2 Settings
I modified the default M2 profile in Simplify3d. Is there a way to reset the profile? I am sure reinstalling would work but was trying to determine if there is another way to get it back.
Thanks
Thanks