Marlin v1.1.6 working, except for bed height

The place to discuss your hardware and software/firmware modifications...

Marlin v1.1.6 working, except for bed height

Postby djw » Thu Nov 23, 2017 10:32 pm

I was able to get Marlin v1.1.6 working with my MakerGear m2 Revision E with the black Z motor.

The only thing thats not 100% is setting the bed height starting point via software (Makergear QuickStart App).
I had to hard code the starting height in firmware, which isnt the best. But its changeable with a recompile / upload.

I also enabled linear advance, and its amazing.

This seems to be working and I havent run into an issue other the above yet.

If anyone is interested in helping me get it 100% then I would feel better about posting the code.
djw
 
Posts: 1
Joined: Thu Nov 23, 2017 10:19 pm

Re: Marlin v1.1.6 working, except for bed height

Postby bratan » Wed Dec 06, 2017 9:32 pm

I'm interested, but not sure I could help :)
I was able to flash factory FW using Arduino 1.8.1 instead of recommended ancient 1.5.x (which caused all kind of conflicts with libraries I'm using)...
bratan
 
Posts: 14
Joined: Thu Sep 28, 2017 1:42 pm


Return to Modifications

Who is online

Users browsing this forum: No registered users and 2 guests