four point upgrade

The place to discuss your hardware and software/firmware modifications...
Post Reply
Robert76
Posts: 2
Joined: Thu Jun 07, 2018 3:57 pm

four point upgrade

Post by Robert76 » Sun Dec 15, 2019 5:58 am

I decided to upgrade my rev d M2 to rev e. by going to the 4 point upgrade to improve the ease of leveling. My christmas present to myself. Unfortunately I have run across a snag. When I removed the heating plate, the heater pad appears to have a factory defect in that a large area is not fastened to the plate. Not sure what to do about that. Is there anywhere to repair this? Perhaps inject some kind of glue under the bubble and place a weight on it? Any ideas, or has anyone had a similar problem? I would like to add a picture, but can't figure out how.

airscapes
Posts: 424
Joined: Wed Jan 31, 2018 11:36 pm

Re: four point upgrade

Post by airscapes » Sat Dec 21, 2019 12:53 am

I am guessing you could remove it without damaging it , it could be glued back on with hit temp RTV. A new plate is $60 so that may be a better option, yours is probably not what it was when it was new..

Post Reply