The endstop & software stack is part of what you're supposed to be testing, not just the new hardware3dPrintingMD wrote: For what its worth I elected to not deal with the endstop at the current point in time.
![Confused :?](./images/smilies/icon_e_confused.gif)
The endstop & software stack is part of what you're supposed to be testing, not just the new hardware3dPrintingMD wrote: For what its worth I elected to not deal with the endstop at the current point in time.
Code: Select all
; allow the bed to fall for 3 seconds
M84
G4 S3
; stop the bed falling by engaging all the motors
M17
; home X & Y
G28 X0 Y0
; move the hotend off the edge of the bed
G1 X215 Y125 F3000
; home Z and move to upward position if applicable
G28 Z0
G1 Z0 F3000
; reset extrusion distance for filament
G92 E0
; poop plastic out for 10 seconds to purge
G1 E25 F250
; smear it on the bed
G1 X190
; lift Z and move to the center of the platform to begin printing
G1 Z3 F600
G1 X102 Y125 F6000
Full kit installed tonight. Endstop fits nice in that spot. Software is easy to follow.insta wrote:The endstop & software stack is part of what you're supposed to be testing, not just the new hardware3dPrintingMD wrote: For what its worth I elected to not deal with the endstop at the current point in time.