2 Additional Thermosistors?
2 Additional Thermosistors?
If I want to use the other thermosistors on the RAMBO board.... what do I need? I have an enclosure that I'd like to monitor the temp, and because of my enclosure I'd like to keep an eye on my extruder stepper temp. I noticed my board has 4 inputs, and I'm only using 2 currently (HBD and Hot End).
Re: 2 Additional Thermosistors?
Ah good question - I'd like to know this too. I just set up a lcd temperature controller in my enclosure (though haven't hooked it up to the fan yet), and see a big difference between temp at the top and bottom of the box (hot air rises - who knew!). Would be nice to monitor both halves. If I can get get the RAMBO to read them, then I can watch graphs of the temps in Octoprint which would be ideal (I only really need a single sensor hooked up to the actual controller though).