v4 Hot End Indicator Mount
v4 Hot End Indicator Mount
I just finished putting in my v4 Hot end upgrade and discovered the most wonderful thing.
Their is a indicator mount built right in to the hot end holder.
if you take out the clamp screw and use a longer one you can mount an indicator right in the thread clearance hole.
A little better look
Their is a indicator mount built right in to the hot end holder.
if you take out the clamp screw and use a longer one you can mount an indicator right in the thread clearance hole.
A little better look
- Attachments
-
- Close UP
- m2 indicator-2.jpg (120.14 KiB) Viewed 14994 times
Re: v4 Hot End Indicator Mount
First Calibration cube with v4 hot end. Man is that thing stable.
-
- Posts: 105
- Joined: Wed Apr 09, 2014 11:36 pm
Re: v4 Hot End Indicator Mount
Looks like the newer V4 mounts are anodized black. The first run of them were not anodized.
Re: v4 Hot End Indicator Mount
Deleted
-
- Posts: 277
- Joined: Fri Oct 02, 2015 5:37 am
Re: v4 Hot End Indicator Mount
Great idea. I have a dial like that, which is way more accurate than the one I have been using, going to give this a try, because I keep running into issues where I am not level.
M2 - V4, MIC-6 Build Plate, Astrosyn Damper's(X/Y), Rev. E, Geeetech LCD
S3D - FFF Settings https://forum.simplify3d.com/viewtopic.php?f=8&t=2367
Print Quality Troubleshooting https://www.simplify3d.com/support/prin ... eshooting/
S3D - FFF Settings https://forum.simplify3d.com/viewtopic.php?f=8&t=2367
Print Quality Troubleshooting https://www.simplify3d.com/support/prin ... eshooting/
Re: v4 Hot End Indicator Mount
That is another "poster boy" for calibration cubes! (Ed and Jin also posted a couple.) Looks great!
Re: v4 Hot End Indicator Mount
Great idea. These lever style dial indicators require less force than plunger style indicators, so they shouldn't compress the bed's springs and give a false reading.
Re: v4 Hot End Indicator Mount
I removed the spring from the plunger in my cheapo indicator. Since gravity always works in the right direction, it's not needed here. It was just a small extension spring out in plain view behind the back plate.Ryan_ wrote:Great idea. These lever style dial indicators require less force than plunger style indicators, so they shouldn't compress the bed's springs and give a false reading.
Re: v4 Hot End Indicator Mount
Worked like a charm!
- Matt_Sharkey
- Posts: 347
- Joined: Mon Oct 20, 2014 3:10 pm
Re: v4 Hot End Indicator Mount
Would I need a high quality indicator for leveling the bed? I was hoping to just buy one of these:
http://www.amazon.com/Surface-Smoothnes ... =indicator
http://www.amazon.com/Surface-Smoothnes ... =indicator