Marlin v1.02 for the M2

The place to discuss your hardware and software/firmware modifications...

Marlin v1.02 for the M2

Postby loiphin » Wed Aug 12, 2015 1:12 pm

Hi all,

I decided to upgrade my firmware from the original M2Marlin24r2 firmware (version 1.0.0RC2) (for 24V / 40W heater) to the latest stable Marlin version 1.02. I have only tested this with Arduino 1.5.5.

- I have kept all the settings stock, except that the extruder and case fan will automatically activate when the extruder hits 50 degrees C. Below 50 it stays off, so it's a bit quieter at least.

- I have enabled thermal runaway protection with default settings.

Open up the sketch in Arduino 1.5.5 and upload to the printer. (Using version 1.6.x of Arduino to compile the firmware causes problems, so stick to 1.5.5)

I have done some test prints and they have come out fine.

The main reason I have built this firmware is in preparation for my Viki 2.0 LCD display. As soon as it arrives (within a week or so of this writing) I will test it out and then upload the Viki 2.0 version of the firmware.


USE AT YOUR OWN RISK. I am not responsible for any mishaps or damage as a result of using this firmware.

Download from my personal Google Drive:

Release A - Marlin v1.02 for Makergear M2 with 24V power supply and 40W extruder heater. ... sp=sharing

Posts: 56
Joined: Mon Jul 27, 2015 5:41 pm
Location: Oslo, Norway

Re: Marlin v1.02 for the M2

Postby rpollack » Wed Aug 12, 2015 10:57 pm

Thank you
User avatar
Posts: 452
Joined: Wed Apr 09, 2014 9:01 pm
Location: Beachwood, OH

Re: Marlin v1.02 for the M2

Postby jsc » Thu Aug 13, 2015 4:03 am

I think insta also has an up to date M2 Marlin fork.
Posts: 1863
Joined: Thu Apr 10, 2014 4:00 am

Re: Marlin v1.02 for the M2

Postby morganfree » Mon Oct 09, 2017 1:43 pm

Good morning!
I know this is an old post, but I got a VIki2 LCD screen and I can't seem to find any certain instruction/firmware to install it. It seems the threads were stopped back in 2015 and nobody could actually install it!??

I have an M2 with old Z engine (silver/black) 24v PS and V4 hotend.

I appreciate a lot your help! Besides this question here, I'll create a post...

Best regards!
User avatar
Posts: 53
Joined: Mon Sep 26, 2016 10:46 pm
Location: Porto Alegre, Brazil

Return to Modifications

Who is online

Users browsing this forum: No registered users and 2 guests