Just wondering if anyone else is running Marlin 1.1RC1 ? I have been using it for a couple of weeks on my M2 with E3Dv6 and it seems to be pretty stable. Not sure what benefit there is over 1.02-1 ?
I compiled it with Arduino 1.6.5 r5
Added the fix to the code which sorts out X/Y shift issues ( when compiling with 1.65)
Running the Viki 2.0 LCD with a 500ms refresh rate. (Refresh seems to help against the extruder slowing down with complex shapes, like curves)
Have the case and extruder heatsink fan activate at >50 degrees extruder temp.
If anyone is interested I am happy to upload a copy of the firmware. I can remove specifics like the Viki2 and/or E3Dv6 settings upon request.
The place to discuss your hardware and software/firmware modifications...
1 post • Page 1 of 1