Page 1 of 1
Has anyone tried one of the laser-cutter/engraver add-ons?
Posted: Wed Dec 09, 2015 4:01 am
by Farr0wn3d
I started looking at the L-Cheapo and that led me to looking at the J-tech ones. The fact that you can engrave photos with an upgraded software is really interesting. Just seeing if anyone has had any experience with anything like this?
Re: Has anyone tried one of the laser-cutter/engraver add-on
Posted: Wed Dec 09, 2015 5:37 am
by lem
Go to this forum and search for JTech:
https://discuss.inventables.com/latest
Re: Has anyone tried one of the laser-cutter/engraver add-on
Posted: Fri Dec 11, 2015 12:59 am
by Earsmith
I was looking at the same thing but decided against it because of the safety factor. If you do it be extremely careful. A stray beam can blind you at that power very easily.
Re: Has anyone tried one of the laser-cutter/engraver add-on
Posted: Fri Dec 11, 2015 5:21 am
by Farr0wn3d
Jtech sells the plastic sheets that block the laser light so I was considering getting a few of them and making an enclosure for the m2