http://e3d-online.com/TemperatureSensors
too bad MakerGear didn't start using these thermistors, what, 24 months ago?
The actual good news is this might allow people who want to run the E3D hotend to wholesale use the MakerGear heater and thermistor cartridges.
E3D ships upgraded bits
E3D ships upgraded bits
Custom 3D printing for you or your business -- quote [at] pingring.org
Re: E3D ships upgraded bits
holy crap its about time. i hated dealing with that tiny thermistor and the sleeving. it was a pia.
Re: E3D ships upgraded bits
So how much of a pain would it be to try and get the firmware working with one of the 3 in 1 out e3d ends?
Re: E3D ships upgraded bits
RAMBo already supports 2 extruders on the board, and there's breakout pins for 3 more if you run a little sub-board with Pololu A4988 drivers. The firmware already supports up to 8 extruders, I think. I don't see why not?
Custom 3D printing for you or your business -- quote [at] pingring.org