LCD Panel instructions

The place to discuss your hardware and software/firmware modifications...
Post Reply
steve220
Posts: 63
Joined: Tue Oct 11, 2016 2:32 pm

LCD Panel instructions

Post by steve220 » Thu Oct 13, 2016 7:34 pm

I searched the forum and found the wiki for the makergear LCD add on, but don't see anything regarding instructions, etc. Does a user guide exist?

User avatar
Jules
Posts: 3150
Joined: Wed Jan 21, 2015 1:36 am

Re: LCD Panel instructions

Post by Jules » Thu Oct 13, 2016 10:35 pm

Anything on the LCD screens will be on the Wiki, or the forum in the Modifications section. (Use the search.) There's been a few things written up on it there.

http://makergear.wikidot.com/m2-lcd-panel

steve220
Posts: 63
Joined: Tue Oct 11, 2016 2:32 pm

Re: LCD Panel instructions

Post by steve220 » Sat Oct 15, 2016 3:25 pm

Thanks Jules,
Seems to be very little out there on the LCD screen. I found this, which may be helpful to others:
https://www.scribd.com/doc/237971715/LC ... n-Firmware

User avatar
Jules
Posts: 3150
Joined: Wed Jan 21, 2015 1:36 am

Re: LCD Panel instructions

Post by Jules » Sat Oct 15, 2016 3:29 pm

Yeah, that does look like it would be helpful! Good find! :)

User avatar
SouthSideofdaSky
Posts: 103
Joined: Wed Jul 09, 2014 9:35 pm

Re: LCD Panel instructions

Post by SouthSideofdaSky » Mon Oct 17, 2016 8:52 pm

I have the LCD upgrade and was also surprised by the lack of information available online. That schematic is somewhat helpful though.

Jebb
Posts: 1
Joined: Mon Oct 31, 2016 9:49 pm

Re: LCD Panel instructions

Post by Jebb » Mon Oct 31, 2016 9:55 pm

Ok guy,
I am new to all of this stuff. But I am attempting to install a VIKI2 to my M2. I am reaching out to a few channels, but I am getting desperate. Maybe I just got the wrong LCD, but it seems to be pretty difficult to pull off. Any help?

User avatar
SouthSideofdaSky
Posts: 103
Joined: Wed Jul 09, 2014 9:35 pm

Re: LCD Panel instructions

Post by SouthSideofdaSky » Fri Nov 04, 2016 7:58 pm

Hi Jebb,

I don't have the Viki2 but have you seen/tried this page? http://makergear.wikidot.com/m2-lcd-panel#toc3

Post Reply