Page 1 of 1
LCD Panel instructions
Posted: Thu Oct 13, 2016 7:34 pm
by steve220
I searched the forum and found the wiki for the makergear LCD add on, but don't see anything regarding instructions, etc. Does a user guide exist?
Re: LCD Panel instructions
Posted: Thu Oct 13, 2016 10:35 pm
by Jules
Anything on the LCD screens will be on the Wiki, or the forum in the Modifications section. (Use the search.) There's been a few things written up on it there.
http://makergear.wikidot.com/m2-lcd-panel
Re: LCD Panel instructions
Posted: Sat Oct 15, 2016 3:25 pm
by steve220
Thanks Jules,
Seems to be very little out there on the LCD screen. I found this, which may be helpful to others:
https://www.scribd.com/doc/237971715/LC ... n-Firmware
Re: LCD Panel instructions
Posted: Sat Oct 15, 2016 3:29 pm
by Jules
Yeah, that
does look like it would be helpful! Good find!
Re: LCD Panel instructions
Posted: Mon Oct 17, 2016 8:52 pm
by SouthSideofdaSky
I have the LCD upgrade and was also surprised by the lack of information available online. That schematic is somewhat helpful though.
Re: LCD Panel instructions
Posted: Mon Oct 31, 2016 9:55 pm
by Jebb
Ok guy,
I am new to all of this stuff. But I am attempting to install a VIKI2 to my M2. I am reaching out to a few channels, but I am getting desperate. Maybe I just got the wrong LCD, but it seems to be pretty difficult to pull off. Any help?
Re: LCD Panel instructions
Posted: Fri Nov 04, 2016 7:58 pm
by SouthSideofdaSky
Hi Jebb,
I don't have the Viki2 but have you seen/tried this page?
http://makergear.wikidot.com/m2-lcd-panel#toc3