Page 1 of 1

How-To: Your M2 and you (newbies pls read kthx)

PostPosted: Wed Nov 16, 2016 5:24 pm
by insta
If you ask a question and it's been covered in one of these well-written guides, you might get rudely dismissed by a very frazzled Jules. You probably won't, but might.

Initial (important):
New machine beginner's guide
Old machine beginner's guide

Getting started

Extruder flowrate calibration
Extruder tension adjustment
The perfect first layer
Leveling an old machine

Helpful tips:
Pausing at a specific layer
Splicing filament as you print

Filament:
Filaments known to work on the M2
Dialing in pesky black PETG

Re: How-To: Your M2 and you (newbies pls read kthx)

PostPosted: Wed Nov 16, 2016 6:16 pm
by Jules
Shame insta! To imply such a thing....he's teasing you newbies.......I'm never frazzled! Chuckle! :lol:

Re: How-To: Your M2 and you (newbies pls read kthx)

PostPosted: Wed Nov 16, 2016 10:01 pm
by Matt_Sharkey
You seem a bit frazzled there jules.

*backs away slowly*

Re: How-To: Your M2 and you (newbies pls read kthx)

PostPosted: Wed Nov 16, 2016 10:24 pm
by Jules
Don't make me get my flying monkeys! :twisted:

Re: How-To: Your M2 and you (newbies pls read kthx)

PostPosted: Tue Apr 11, 2017 9:53 pm
by kingstonsteele
Well, like I said it's been working and then all of a sudden did not. I received it on Wednesday last week. I looked through manuals and did some research online. I figured the next best thing was to ask people directly. I'm sure I COULD find the answer but then it becomes a question of which is the most efficient route? Search through countless pages of manuals looking for something that I don't even know I'm looking for or ask the kind people of MakerGear Forum. Hopefully I have not frazzled anyone :D