MakerGear Forum

Hey all, I did some searches, but maybe I don't have the right terms. Does anyone have a model of the entire machine or at least the extruder? I'm trying to design a print fan using a 50mm blower that blows at 270-360 degrees around the nozzle.

Thanks in advance.

The first place I'd check would be the Github repo: https://github.com/MakerGear/M2

I have only found the 3D printed pieces, not the whole extruder assembly on Github.

It could just be me but if your new to the north there are better ways to warm your room in the winter.

SLCJedi wrote:I have only found the 3D printed pieces, not the whole extruder assembly on Github.

Ah...I see. So you want a full 3d model of this entire assembly?

That's it. I have now modeled most of the important bits. So kind of a moot point.

SLCJedi wrote:That's it. I have now modeled most of the important bits. So kind of a moot point.

Would you mind sharing? It would be great to have for a modding reference point.

Sure. I will upload to thingiverse as an STL. I'm using 123D Design, so not many options for files unless you use 123D as well.

Here is what I have as a crazy dual 50mm blower option. Still have to work out the bracketry. I will also make a single 50mm blower version as the dual may be a lot of weight.

Basic model for orientation in SLT and 123dx here:

http://www.thingiverse.com/thing:1932742

thank you very much for sharing this, should make my future modifications much easier to implement!