e3D Titan Aero

The place to discuss your hardware and software/firmware modifications...
Post Reply
felt342
Posts: 2
Joined: Wed Mar 06, 2019 8:16 pm

e3D Titan Aero

Post by felt342 » Mon Jul 29, 2019 12:52 pm

Hello folks,

I have e3D Titan setup installed on my M2 rev.E. I start to thinking of switching to Titan Aero. But there is one issue with it. Its seems what it will be not enough length for nozzle too reach build plate. Is there anybody tried to figure out something? What I have in mind is to order custom made heat break which would be about 30mm long, but thats might be too expensive and hard to get it proper. Or maybe longer nozzle? But then might appears leaking issue?

Issue is what motor should be about 7mm lower to make it possible.

Thanks in advance.

Post Reply