Page 1 of 1

e3D Titan Aero

Posted: Mon Jul 29, 2019 12:52 pm
by felt342
Hello folks,

I have e3D Titan setup installed on my M2 rev.E. I start to thinking of switching to Titan Aero. But there is one issue with it. Its seems what it will be not enough length for nozzle too reach build plate. Is there anybody tried to figure out something? What I have in mind is to order custom made heat break which would be about 30mm long, but thats might be too expensive and hard to get it proper. Or maybe longer nozzle? But then might appears leaking issue?

Issue is what motor should be about 7mm lower to make it possible.

Thanks in advance.