I've been working on a dual extruder for my M2. I had planned on using the bowden feed system, but I realized that I don't have any experience setting up an extruder for the bowden system.
After getting used to tuning my M2, I'm worried the bowden will be a pain to tune- anyone have M2 bowden feedback?
Dual Extruder Bowden or not?
-
- Posts: 42
- Joined: Fri Apr 11, 2014 10:06 pm
Dual Extruder Bowden or not?
- Attachments
-
- dual2.jpg (158.53 KiB) Viewed 6771 times
-
- dual1.jpg (99.73 KiB) Viewed 6771 times
Re: Dual Extruder Bowden or not?
I'm running a Kossel with bowden and I think it is the biggest pain. I would go direct drive if I could but on a Delta it's about weight and size.