Hello, I am new to the forum and have a question about HatchBox Filament.
What are the Temp. with PLA Heater & Bed ?
Thanks...
HatchBox Filament
-
- Posts: 277
- Joined: Fri Oct 02, 2015 5:37 am
Re: HatchBox Filament
Heated bed 55-60.
Extruder - 205 has worked well. What color are you using ?
Extruder - 205 has worked well. What color are you using ?
M2 - V4, MIC-6 Build Plate, Astrosyn Damper's(X/Y), Rev. E, Geeetech LCD
S3D - FFF Settings https://forum.simplify3d.com/viewtopic.php?f=8&t=2367
Print Quality Troubleshooting https://www.simplify3d.com/support/prin ... eshooting/
S3D - FFF Settings https://forum.simplify3d.com/viewtopic.php?f=8&t=2367
Print Quality Troubleshooting https://www.simplify3d.com/support/prin ... eshooting/
Re: HatchBox Filament
if you use the wood one u can go a lil down most wood pla like 195-200
for the bed it really depend from the bed type if you talking about glass or pei or tape most probably 55-60
if you talk about Zebra plate i usually print between 37-38
another factor is the room in which u are printing if is conditioned or if there is possible breeze passing near the printer if is cold if is humid...
if is near a windows and outside is cold etcetc i notice it does matter the air around the printer (thats why some printer are close make it easier to eliminate that variable)
for the bed it really depend from the bed type if you talking about glass or pei or tape most probably 55-60
if you talk about Zebra plate i usually print between 37-38
another factor is the room in which u are printing if is conditioned or if there is possible breeze passing near the printer if is cold if is humid...
if is near a windows and outside is cold etcetc i notice it does matter the air around the printer (thats why some printer are close make it easier to eliminate that variable)