Filament Discussions

The place to discuss filament...
Post Reply
User avatar
Posts: 490
Joined: Wed Apr 09, 2014 9:01 pm
Location: Beachwood, OH

Filament Discussions

Post by rpollack » Fri May 16, 2014 7:20 pm

You are welcome to discuss filaments you are using, techniques, strengths/weaknesses, etc. Please do not promote competitive products.

Posts: 7
Joined: Mon Apr 14, 2014 11:59 pm

Re: Filament Discussions

Post by davycroc » Wed Jan 21, 2015 2:16 am

NinjaFlex 3mm
0.2mm layer height with an .050 nozzle
20mm/sec max speed

This has to print very slowly, the NinjaFlex doesn't melt very fast, and trying to cram too much of it into the extruder just jams up.
But, if you are patient, you can print some really neat stuff, like the adipose from Dr. Who (2005).

Watch the infill, if you do support only, it squeezes "funny".
Do a light infill for squeezability (<25%), and more (>50%) for a "firmer" feel.

If you are doing repeated flexing, make the walls thicker to handle the inevitable layer separation.

Post Reply