Page 1 of 1

Filament Discussions

Posted: Fri May 16, 2014 7:20 pm
by rpollack
You are welcome to discuss filaments you are using, techniques, strengths/weaknesses, etc. Please do not promote competitive products.

Re: Filament Discussions

Posted: Wed Jan 21, 2015 2:16 am
by davycroc
NinjaFlex 3mm
250-260C
0.2mm layer height with an .050 nozzle
20mm/sec max speed

This has to print very slowly, the NinjaFlex doesn't melt very fast, and trying to cram too much of it into the extruder just jams up.
But, if you are patient, you can print some really neat stuff, like the adipose from Dr. Who (2005).

Watch the infill, if you do support only, it squeezes "funny".
Do a light infill for squeezability (<25%), and more (>50%) for a "firmer" feel.

If you are doing repeated flexing, make the walls thicker to handle the inevitable layer separation.

Re: Filament Discussions

Posted: Thu Jan 02, 2020 9:06 pm
by Joaquin87
Hello,

I want to try out the Ninjaflex TPU 1.75mm, but not sure which parameters do I need to use, especially the print speed.
I'm now using a 0.35mm nozzle.
My goal is to work with the infill and create a 'metamaterial mechanism'

The printer is an M2 V4

Thanks,