Page 1 of 1
Polycarbonate print
Posted: Wed Apr 08, 2015 2:44 pm
by rsilvers
MakerGear M2 with E3D, 1/10 scale, 290C, 50 micron layers, GizmoDorks Polycarbonate, 60 mm/sec.
Re: Polycarbonate print
Posted: Wed Apr 08, 2015 3:28 pm
by insta
rsilvers wrote:MakerGear M2 with E3D, 1/10 scale, 290C, 50 micron layers, GizmoDorks Polycarbonate, 60 mm/sec.
Can you go put that in my "filaments that work" thread? Picture, too.
Re: Polycarbonate print
Posted: Thu Apr 09, 2015 5:13 am
by Jules
Wow!
Gorgeous detail!
Re: Polycarbonate print
Posted: Mon May 18, 2015 5:07 pm
by dave2brecht
What extruder and bed temp did you use? What bed surface?
Re: Polycarbonate print
Posted: Mon May 18, 2015 5:18 pm
by rsilvers
110-120 bed temp.
Bare glass with purple Elmer's glue.