Page 1 of 1
colorfabb xt
Posted: Fri Apr 24, 2015 12:33 pm
by PcS
If anybody has a profile for this and would like to post it I would appreciate it. I am getting mixed results and having a hard time dialing this in for some reason . Thanks in advance !
Re: colorfabb xt
Posted: Fri Apr 24, 2015 2:06 pm
by jimc
Pat, were you using an e3d hotend? V3b, v4...i cant remember
Re: colorfabb xt
Posted: Fri Apr 24, 2015 2:51 pm
by rsilvers
Just print it at 250C and slow down the speed to 3200. I am not sure what is best for layer height, but I use 0.2mm.
Make sure to do an extrustion-multiplier test.
Re: colorfabb xt
Posted: Fri Apr 24, 2015 3:32 pm
by PcS
V4 hot end l jimc . I will give that a try rs .Thanks.