Page 1 of 1

eSUN PETG Problem

Posted: Sat Apr 16, 2016 7:04 pm
by RJD
I attempted to utilize eSUN red and blue PETG following Jules' post about eSUN black as a reference for settings, but the following picture illustrates what is happening a few minutes into the print. I have never had this problem with PLA or ABS. What is the cause and fix? Thanks.

Re: eSUN PETG Problem

Posted: Sat Apr 16, 2016 10:23 pm
by Jules
Looks like it jammed and stripped. Check your Filament Drive Screw tension.

viewtopic.php?f=3&t=2694

Re: eSUN PETG Problem

Posted: Sun Apr 17, 2016 2:30 am
by PcS
Can I ask print.speed and.nozzle temp ?

Re: eSUN PETG Problem

Posted: Sun Apr 17, 2016 3:00 am
by RJD
It seems the problem is fixed, but will print some more tomorrow to make sure. I adjusted temp on extruder, slowed down the speed, and adjusted drive screw tension, so essentially trial and error. Thanks.