Abs settings
-
Deereengineer
- Posts: 21
- Joined: Mon Nov 30, 2015 9:38 pm
Abs settings
Can someone direct me to a good abs settings thread similar to the thread about petg that is pinned to the front page?
Re: Abs settings
I have a recent thread about getting good print on top of support with ABS here:
viewtopic.php?f=7&t=3796
Toward the end of this thread I posted a factory file with my final setup. This is for Hatchbox ABS. I'm printing on PEI over Aluminum with ABS juice on the PEI.
Can't claim that this is the ultimate - my main goal was to get clean print on top of the support and good bed adhesion. Haven't done a large ABS print with this setup, so don't know where I stand with that yet.
viewtopic.php?f=7&t=3796
Toward the end of this thread I posted a factory file with my final setup. This is for Hatchbox ABS. I'm printing on PEI over Aluminum with ABS juice on the PEI.
Can't claim that this is the ultimate - my main goal was to get clean print on top of the support and good bed adhesion. Haven't done a large ABS print with this setup, so don't know where I stand with that yet.