The place to discuss filament...
3 posts • Page 1 of 1
I'm having a hell of a time printing this stuff. it keeps popping off at like the 3rd or 4th layer. Runing 265 temp 50C on bed with PEI and MIC6 plate... pretty much set up using jules settings for PETG.... anyone have any idea what I'm doing wrong?
Get a sheet of garolite le. It's like the PEI for nylon. I have to sheets of the MG glass and one has PEI and the other has garolite le. Both 1/16". Only have to tweek the z offset a tad to get the extruder at the proper offset, if you don't want to physically adjust it. But with the V4, it probably easier to use your feeler gauges and an allen wrench. Love the simplicity.