Page 1 of 1
filaflex
Posted: Sun Aug 06, 2017 5:18 am
by psd
Has anyone had any experience with filaflex?
ninjaflex was slowwwwww and hard to pass through extruder, trying to find a more efficient flexible filament.
Re: filaflex
Posted: Mon Aug 07, 2017 4:16 pm
by Phil
I would suggest Makerflex from MakerGeeks. It may not be quite as soft as Ninjaflex, but it also seems tougher and is definitely a lot less expensive.
Re: filaflex
Posted: Thu Aug 10, 2017 7:50 am
by psd
Phil wrote:I would suggest Makerflex from MakerGeeks. It may not be quite as soft as Ninjaflex, but it also seems tougher and is definitely a lot less expensive.
Can you get better feed? Better print feeds with it?
Re: filaflex
Posted: Mon Aug 14, 2017 5:00 am
by jimc
filaflex has been around for a long time. its been awhile but i remember a comparison review of 5 or so flexibles. i remember the filaflex not being any faster. try the cheetah filament. its a little faster than ninjaflex but keep in mind any flexible will be slow. thats just the way it is
Re: filaflex
Posted: Wed Aug 16, 2017 9:56 pm
by Phil
psd wrote:Phil wrote:I would suggest Makerflex from MakerGeeks. It may not be quite as soft as Ninjaflex, but it also seems tougher and is definitely a lot less expensive.
Can you get better feed? Better print feeds with it?
I have had great success with both Makerflex and Ninjaflex. I have posted on "Insta's Filaments that Work on the M2" thread.
Re: filaflex
Posted: Wed Aug 16, 2017 10:05 pm
by psd
I have had great success with both Makerflex and Ninjaflex. I have posted on "Insta's Filaments that Work on the M2" thread.[/quote]
super, just bought some MakerFlex can you include the link to your post?
thanks
Re: filaflex
Posted: Thu Aug 17, 2017 2:54 pm
by Phil
psd wrote:I have had great success with both Makerflex and Ninjaflex. I have posted on "Insta's Filaments that Work on the M2" thread.
super, just bought some MakerFlex can you include the link to your post?
thanks[/quote]
The thread is as the top of the "Filament" group heading. I recommend reading all the posts; very beneficial information.
Re: filaflex
Posted: Thu Aug 17, 2017 3:55 pm
by psd
The thread is as the top of the "Filament" group heading. I recommend reading all the posts; very beneficial information.[/quote]
Hi Phil,
I have read through all posts on Filaments that work and saw many from you, however I do not see one on Makerflex????
am I just blind?
Re: filaflex
Posted: Thu Aug 17, 2017 10:49 pm
by Phil
psd wrote:am I just blind?
No, my fault. I thought it was there, but in fact, it is here:
viewtopic.php?f=11&t=3971