Re: Need Flexible Filament advice
Posted: Mon Jan 06, 2020 2:34 am
Why is necessary "Gravity feed" for TPU?airscapes wrote: ↑Thu Sep 06, 2018 10:00 pm6mmS .. Ok, had it running at 8 and it seemed to work better a bit faster. Just finished a spool center for the little slash spool to put it on a dowel above the printer..
Also, the NinjaFlex dampers work fairly well, not as good as a real damper for noise, but a good amount of noise reduction "without" the shaft issues of the other dampers. I only made the damper or Gasket is a better term 1mm thick.. Longer screws are needed to go thicker.
Thanks for the input going to do some more testing tonight.
Is this about as good as it get?
This good for Gravity feed?