Page 1 of 1

What are all the allen wrenches in the M2 toolset?

Posted: Tue Oct 28, 2014 4:30 am
by insta
EVERY Allen wrench I own is in a big pile for some reason. I want to separate out the ones used on the M2 -- which ones should I set aside?

Re: What are all the allen wrenches in the M2 toolset?

Posted: Tue Oct 28, 2014 5:56 pm
by Dale Reed
Insta,

Perhaps the picture on page 6 of this document ( http://cdn.shopify.com/s/files/1/0030/7 ... ox.pdf?877 ) will help. (NOTE: the document shows the older dual-supply M2, with 12 volt and 19 volt bricks -- but aside from the new V3B hot end and the new single 24 volt supply, the document should be quite close. The tools on page 6 should be right on.)

I would guess the following: The M3 (I think it's 2.5 mm) hex driver, the M4 (I think it's 3 mm) hex driver, and the metric hex keys from about 1.5 to 5 mm or so should cover the M2 through M6 hardware used on the M2 printer.

But an e-mail to MakerGear support should result in a response with the definitive list of tools from their Bill of Materials...

Dale

Re: What are all the allen wrenches in the M2 toolset?

Posted: Wed Feb 18, 2015 4:36 am
by Ronnien55
Just a quick note, After looking at the picture of tools, of course i have had my M2 for a couple of months ,but I never received the M4 driver.

Re: What are all the allen wrenches in the M2 toolset?

Posted: Wed Feb 18, 2015 6:49 am
by insta
Ronnien55 wrote:Just a quick note, After looking at the picture of tools, of course i have had my M2 for a couple of months ,but I never received the M4 driver.
I think they stopped sending that one after awhile. My second M2 from MG only had the M3 driver, but the full complement of allen wrenches.

Re: What are all the allen wrenches in the M2 toolset?

Posted: Sat Feb 21, 2015 8:09 pm
by Ronnien55
Thanks, I did have all the Allen wrenches as well.