S3D Issues printing from SD card

The official subforum for discussion of the installation and use of the official M2 Dual Extruder upgrade.

S3D Issues printing from SD card

Postby Capt. John » Wed Oct 04, 2017 7:09 pm

I get one print from the SD card. Then the machine or code hangs up even though printing temp parameters
have been met. Program works OK in normal mode, but not when reordering more prints from the SD card.

If I shut down the program and bring it back up again, it will print one from the SD card, but no more.

Any ideas?

Had the dual extruder kit for a couple of years and just got around to updating my machine to 2 nozzles.
Capt. John
Manistee, Michigan
Reel Amateur at 3D printing
Fishing Tackle Manufacturer & Webmaster for:
http://www.michiganangler.com
http://www.michigansportsman.com
User avatar
Capt. John
 
Posts: 271
Joined: Sun Apr 13, 2014 7:48 pm
Location: Manistee, MI

Re: S3D Issues printing from SD card

Postby Gwhite » Thu Oct 05, 2017 12:40 am

I have found that I have to hit the reset button on the front of the electronics box in between print jobs. I haven't tried printing the same file twice off an SD card, but if I want to print from the SD card after I've swapped it out to update the file, I always have to reset the printer.
Gwhite
 
Posts: 102
Joined: Tue Jul 11, 2017 3:38 pm

Re: S3D Issues printing from SD card

Postby Capt. John » Thu Oct 05, 2017 5:05 am

Narrowing this down to software issue with win 7.

Win 7 does not have the necessary .dll on my puter to run S3D 4.0.
Can use only 3.0. Put 4.0 on my laptop and will see if this cures the problem.

I production print fishing tackle diver rings that Jim C designed for me.
Attachments
Cupped_Diver_Rings.jpg
Capt. John
Manistee, Michigan
Reel Amateur at 3D printing
Fishing Tackle Manufacturer & Webmaster for:
http://www.michiganangler.com
http://www.michigansportsman.com
User avatar
Capt. John
 
Posts: 271
Joined: Sun Apr 13, 2014 7:48 pm
Location: Manistee, MI


Return to M2 Dual Extruder

Who is online

Users browsing this forum: No registered users and 2 guests