Re: Anyone want to share their process files?
Posted: Wed Sep 02, 2015 1:06 am
This forum would look like a pincushion if I had sticky capabilities 
MakerGear Forum
The Place To Discuss MakerGear 3D Printers!
http://forum.makergear.com/
Anyone want to share their process files?
Page 2 of 2
Re: Anyone want to share their process files?
Posted: Wed Sep 02, 2015 1:53 am
Check out the "M2 tips" thread in the tips forum, which gathers together a lot of helpful links. I should update it sometime, it's been a while, but the extrusion calibration stuff is linked from there as well.
Re: Anyone want to share their process files?
Posted: Wed Sep 02, 2015 10:43 pm
That's here, and if you haven't done it yet, you aren't getting good results yet:nirfriedman wrote:.....Finally, as a newbie it would be useful to learn what are the issues I should check for. For example, what are "extrusion calibration" mentioned by jsc? and how does one go about doing such tests? having a pinned post that mentions the test you want to go through on your machine would be super-useful.
Nir
viewtopic.php?f=3&t=1964