Dual Extruder question

The official subforum for discussion of the installation and use of the official M2 Dual Extruder upgrade.
sprior
Posts: 381
Joined: Thu Apr 10, 2014 8:37 pm

Re: Dual Extruder question

Post by sprior » Sat Aug 09, 2014 3:16 am

The dual kit did come with another spool holder, but I sometimes print with plastic that comes on spools with smaller diameter holes and had already replaced my left spool holder with this thinner one: http://www.thingiverse.com/thing:150416 so I printed a second one of those and now have the thinner holder for both.

User avatar
Capt. John
Posts: 271
Joined: Sun Apr 13, 2014 7:48 pm
Location: Manistee, MI
Contact:

Re: Dual Extruder question

Post by Capt. John » Sat Aug 09, 2014 9:46 pm

Seen the second spool mount in my kit.

Timing on my part will be weeks behind the leaders here
and foresee this going smoothly.

Wiper technology will undoubtedly have a major retraction like jimc's factory file for PET+.
Retraction does relieve some tendency to stop hot end drip, with the extra moment
biting into the filament even better.

Found out PET+ can use a little tension on the drive tightening nut, but moving
to abs, the drive has to be tightened more. PET is semi soft, abs is a lot harder material.
Capt. John
Manistee, Michigan
Reel Amateur at 3D printing
Fishing Tackle Manufacturer & Webmaster for:
http://www.michiganangler.com
http://www.michigansportsman.com

Post Reply