Page 2 of 2
Re: Dual Extruder question
Posted: Sat Aug 09, 2014 3:16 am
by sprior
The dual kit did come with another spool holder, but I sometimes print with plastic that comes on spools with smaller diameter holes and had already replaced my left spool holder with this thinner one:
http://www.thingiverse.com/thing:150416 so I printed a second one of those and now have the thinner holder for both.
Re: Dual Extruder question
Posted: Sat Aug 09, 2014 9:46 pm
by Capt. John
Seen the second spool mount in my kit.
Timing on my part will be weeks behind the leaders here
and foresee this going smoothly.
Wiper technology will undoubtedly have a major retraction like jimc's factory file for PET+.
Retraction does relieve some tendency to stop hot end drip, with the extra moment
biting into the filament even better.
Found out PET+ can use a little tension on the drive tightening nut, but moving
to abs, the drive has to be tightened more. PET is semi soft, abs is a lot harder material.