Wiper

The official subforum for discussion of the installation and use of the official M2 Dual Extruder upgrade.
Rocketdog
Posts: 26
Joined: Fri May 02, 2014 7:33 pm

Re: Wiper

Post by Rocketdog » Sat Aug 09, 2014 2:04 am

My 2nd extruder ran backwards and it turned out that reversed the harness' in the wire cover. It became evident when the first print had tool paths 62 mm apart on the bed. They are now on top of each other

Rocketdog
Posts: 26
Joined: Fri May 02, 2014 7:33 pm

Re: Wiper

Post by Rocketdog » Sat Aug 09, 2014 10:47 pm

Here is an example of a Cura ooze shield and prime tower. I had to use a brim to keep the tower from getting knocked over. There is a robot in there somewhere

Rocketdog
Posts: 26
Joined: Fri May 02, 2014 7:33 pm

Re: Wiper

Post by Rocketdog » Sat Aug 09, 2014 10:52 pm

.
Attachments
image.jpg
(829.46 KiB) Downloaded 383 times

Josh
Site Admin
Posts: 91
Joined: Thu Apr 10, 2014 3:32 pm

Re: Wiper

Post by Josh » Tue Aug 12, 2014 8:59 pm

Dale, the only difference between the dual .factory file posted on the wiki, and that print you saw, was the extrusion multiplier - the .factory is set to 0.90 (standard PLA), while the print I was running on Friday was at 0.87 for both nozzles, both processes.

Post Reply