Dual extrusion knot

The official subforum for discussion of the installation and use of the official M2 Dual Extruder upgrade.
Post Reply
jsc
Posts: 1864
Joined: Thu Apr 10, 2014 4:00 am

Dual extrusion knot

Post by jsc » Fri Aug 22, 2014 3:54 pm

Another dual extruder test. I would not count this as a success, since the bottom has lots of threads of the wrong color embedded in the layers from the support, but it looks okay from the top. I used the ooze shield for this, which was insanely hard to remove, but with a retraction of 16mm, it may not be necessary.
Attachments
dualknot1.jpg
dualknot1.jpg (92.64 KiB) Viewed 4590 times
dualknot2.jpg
dualknot2.jpg (122.03 KiB) Viewed 4590 times

markb
Posts: 180
Joined: Tue Apr 15, 2014 11:06 pm

Re: Dual extrusion knot

Post by markb » Fri Aug 22, 2014 4:45 pm

That turned out nice.

Post Reply