The v4 dual extruder needs more clearance on the right edge than the v3b, so I modeled up a mount to set a webcam further back. http://www.thingiverse.com/thing:443466
It may be wiser to set it even further back than I have it, as it is physically possible for the diagonal fan to contact my camera, but not with my normal startup sequence.
Camera mount suitable for dual extruder
Camera mount suitable for dual extruder
- Attachments
-
- m2-camera-mount.jpg (162.46 KiB) Viewed 4871 times
Re: Camera mount suitable for dual extruder
Thanks I needed a new one.