Camera mount suitable for dual extruder
Posted: Thu Aug 28, 2014 7:50 am
The v4 dual extruder needs more clearance on the right edge than the v3b, so I modeled up a mount to set a webcam further back. http://www.thingiverse.com/thing:443466
It may be wiser to set it even further back than I have it, as it is physically possible for the diagonal fan to contact my camera, but not with my normal startup sequence.
It may be wiser to set it even further back than I have it, as it is physically possible for the diagonal fan to contact my camera, but not with my normal startup sequence.