Working the dual upgrade in with my old frankenprinter?

The official subforum for discussion of the installation and use of the official M2 Dual Extruder upgrade.
Post Reply
User avatar
insta
Posts: 2007
Joined: Tue Sep 16, 2014 3:59 am

Working the dual upgrade in with my old frankenprinter?

Post by insta » Tue Sep 16, 2014 4:28 am

I've got one of the really old M2's ... back from the RAMBO 1.0 days and dual-PSUs. I've since upgraded to RAMBO 1.3 and 24v (before the official kit came out) but the rest of my machine has remained stock save a Viki I got from the MakerGear store.

The problem I have comes from the E0 motor. The instructions seem to depend on my ability to feed wires through holes on the plastic harness doohickey. My Z motor is wired straight into my harness and does not use the JST connector like E1 does. If my only option is to cut and resolder, I can, but is there another way to handle this?
Custom 3D printing for you or your business -- quote [at] pingring.org

Post Reply