Dual Material prints with new Simplify3D v3.. anybody?

sprior · Post by **sprior** » Thu Jul 16, 2015 11:01 pm

3.0.1 came out a couple of days ago, haven't installed it yet.

sprior · Post by **sprior** » Tue Jul 21, 2015 4:04 am

Tim, doesn't look like 3.0.1 make the left extruder the primary - I'm looking through the default fff profile now. What a pain in the neck to fix.

Tim · Post by **Tim** » Tue Jul 21, 2015 2:30 pm

sprior wrote:Tim, doesn't look like 3.0.1 make the left extruder the primary

I wasn't holding my breath.

But, the 3.0.1 changelog says

Improved bed and extruder setpoint tracking so that input boxes will not be affected when the temperature is turned off at the end of a print

so at least they fixed that one.