Slicer problems
Posted: Wed Aug 24, 2016 7:00 am
Ok, so this is probably a really stupid question, but I'm new . I recently upgraded to a dual extruder, but when I try to slice models with support structure, it's does everything in one extruder. I went into my settings(using slic3r), and it says extruder 1 for infill, and extruder 2 for supports and rafts. But my printer specifies my extruders as 0 and 1, not 1 and 2. Slic3r will not let me use the name extruder 0.
As I said, probably stupid question.
As I said, probably stupid question.