What's different between the dual beta kit and the current?

The official subforum for discussion of the installation and use of the official M2 Dual Extruder upgrade.

What's different between the dual beta kit and the current?

Postby insta » Mon Nov 21, 2016 3:24 am

Title says it all -- hoping somebody from MG can chime in here. My dual came with a PTFE v4, all-metal v4, the dual mount, the motor mount, a harness, and this complicated printed part you swirl the wiring through. One of my wires failed, so I was going back through the guide to replace the harness, and it's all different.

I'm printing a newer motor cap thingy (since honestly it looks easier) but what else should I change?
Custom 3D printing for you or your business -- quote [at] pingring.org
User avatar
Posts: 1998
Joined: Tue Sep 16, 2014 3:59 am

Re: What's different between the dual beta kit and the curre

Postby Jules » Mon Nov 21, 2016 6:17 am

I can send you the write-up for the new machine tomorrow insta....i have to get up at an ungodly early hour tomorrow. The wire cover (hood) over the motors is different, the filament drives are nicer because they have a seat for the clear tubes, and the wrap for the heater wires is greatly improved in the new models. (You should be able to just print the wire hood cover and switch it out though....i think.)

Oh, what the hell....here you go:

MakerGear M2 V4 Rev. E Dual Extruder Setup.zip
(5.46 MiB) Downloaded 105 times
User avatar
Posts: 3150
Joined: Wed Jan 21, 2015 1:36 am

Return to M2 Dual Extruder

Who is online

Users browsing this forum: No registered users and 2 guests