Removing the dual extruder

The official subforum for discussion of the installation and use of the official M2 Dual Extruder upgrade.
Post Reply
Posts: 64
Joined: Sun Jul 31, 2016 8:26 pm

Removing the dual extruder

Post by crazyg0od33 » Tue May 09, 2017 2:11 pm

Hey all! After a little less than a year, I've realized that the dual extruder was kind of a waste for me.

Is there an easy guide to remove it, or is it basically just work backwards from the guide used to install it?


Posts: 277
Joined: Fri Oct 02, 2015 5:37 am

Re: Removing the dual extruder

Post by 3dPrintingMD » Tue May 09, 2017 4:46 pm

I came to the same conclusion and removed mine.

You can look for the V4 hotend instructions. ... 7274837590
M2 - V4, MIC-6 Build Plate, Astrosyn Damper's(X/Y), Rev. E, Geeetech LCD

S3D - FFF Settings
Print Quality Troubleshooting ... eshooting/

Post Reply