Which Firmware for this??
Which Firmware for this??
Haven't used my printer since having to replace the Rambo board. When I did, I also added the Dual upgrade, and bottom Z-Stop and I have the Silver (older style) z-stop motor. . Bit confused on which firmware I should be using. I see a firmware for a system upgraded with 4 point leveling and z-stop upgrade, but no mention of duals. Then the one for a 24v silver motor with duals, but old style leveling.
-
- Posts: 105
- Joined: Wed Apr 09, 2014 11:36 pm
Re: Which Firmware for this??
I would ping MG's tech support to see if they can send you firmware configured for your system.