Page 1 of 1

Which Firmware for this??

Posted: Tue Jun 06, 2017 3:16 am
by daveb
Haven't used my printer since having to replace the Rambo board. When I did, I also added the Dual upgrade, and bottom Z-Stop and I have the Silver (older style) z-stop motor. . Bit confused on which firmware I should be using. I see a firmware for a system upgraded with 4 point leveling and z-stop upgrade, but no mention of duals. Then the one for a 24v silver motor with duals, but old style leveling.

Re: Which Firmware for this??

Posted: Tue Jun 06, 2017 2:11 pm
by thunderbt3
I would ping MG's tech support to see if they can send you firmware configured for your system.