Extruder now moving left too far - making grinding sound
Posted: Thu Apr 19, 2018 4:44 am
I just installed the dual upgrade kit.
However, now when I use the "M2E Z Offset Adjustment (v0.5.0)" the extruder (now dual) just keeps trying to push far left (almost like it's trying to go off rail) which ends up making this loud grinding sound for about 5 seconds (which is because it keeps trying move left on the rail with no more room) and then it goes back to working normally...
Has anyone experienced this or know what I'm referring to? I feel pretty confident about the install overall.
However, now when I use the "M2E Z Offset Adjustment (v0.5.0)" the extruder (now dual) just keeps trying to push far left (almost like it's trying to go off rail) which ends up making this loud grinding sound for about 5 seconds (which is because it keeps trying move left on the rail with no more room) and then it goes back to working normally...
Has anyone experienced this or know what I'm referring to? I feel pretty confident about the install overall.