Dual extruder resetting mid-print when using CURA
Posted: Thu Apr 19, 2018 7:02 pm
Just upgraded my M2E to dual last night, not too difficult but some minor issues have come up...
Currently, when a print is about 50% complete the extruder apparently decides to go ahead and shift off the print to right (waaaay off, well over 100% off) and continues printing in the new spot (which obviously fails the print).
I'm using CURA 3.2.
I don't notice any strange mechanical movements/sounds when this occurs.
I find this issue very perplexing, almost as the most extreme example of layer shifting but the printer doesn't return to it's original position... Has anyone ever seen or heard of an issue like this?
Currently, when a print is about 50% complete the extruder apparently decides to go ahead and shift off the print to right (waaaay off, well over 100% off) and continues printing in the new spot (which obviously fails the print).
I'm using CURA 3.2.
I don't notice any strange mechanical movements/sounds when this occurs.
I find this issue very perplexing, almost as the most extreme example of layer shifting but the printer doesn't return to it's original position... Has anyone ever seen or heard of an issue like this?