printable right hand filament drive for dual v4 extruder?

The official subforum for discussion of the installation and use of the official M2 Dual Extruder upgrade.
Post Reply
chuck
Posts: 9
Joined: Sun Nov 22, 2015 6:38 pm

printable right hand filament drive for dual v4 extruder?

Post by chuck » Tue May 14, 2019 5:56 pm

Dear folks,
I want to set up a BL touch connected to the right hand extruder of my Dual M2. I havent found a model to print, so i would be happy to design my own by modifying the designs, but i can't find them anywhere. I did get to a repository here: https://github.com/MakerGear/M2/tree/ma ... 4%20Hotend, but the files i found (specifically i think this is what i need : ( Dual Filament Drive Right r2.STEP ) cannot be read by software. i can neither read the STEP files nor import them (not even the stls).

an anyone help? Any or all of the following would bring me forward:

1. a valid STEP file of the left or right filament drive
2. an already modified either left or right filament drive i can print
3. a good tutorial for the DUAL extruder?

I hope you can help! !!

thanks in advance anyway,
Chuck

chuck
Posts: 9
Joined: Sun Nov 22, 2015 6:38 pm

Re: printable right hand filament drive for dual v4 extruder?

Post by chuck » Thu May 16, 2019 8:07 pm

no worries, i got it. i had to pull it from github

duh

Post Reply