Help needed updating Arduino 1.5.5r.2
Posted: Thu Dec 05, 2019 9:24 pm
Jason said I needed to update the Rambo board for SD3 to see both extruders in my M2 kit.
Downloaded Arduino, came as a zip file on my windows 7 computer.
Being a zip file after it's unzipped which file do I load on a SD card to plug into the rambo?
All of them, or what?
I know to the experienced this is a piece of cake, in my case it's as clear as mud.
Purchased this kit when they first came out. New hot end is way better than
to old one. I am currently making production parts with hot end 0.
Any help will be much appreciated.
Thanks beforehand!
Downloaded Arduino, came as a zip file on my windows 7 computer.
Being a zip file after it's unzipped which file do I load on a SD card to plug into the rambo?
All of them, or what?
I know to the experienced this is a piece of cake, in my case it's as clear as mud.
Purchased this kit when they first came out. New hot end is way better than
to old one. I am currently making production parts with hot end 0.
Any help will be much appreciated.
Thanks beforehand!