Other stuff you would like to discuss...
-
warrenm
- Posts: 1
- Joined: Tue Mar 29, 2016 2:04 am
Post
by warrenm » Wed Mar 30, 2016 3:50 am
I took some thermal images of the M2 with the heaters on, mostly to see how consistently heated the bed is and what sort of effect the buildtak has on the bed temperature. These images include an overlaid visible-light outline, which is why the M2/MAKERGEAR lettering is showing up. The 205c extruder is outside the 150c limit of the thermal sensor.
- Full unit, bed heated to 60c, extruder heated to 205c
- FLIR0005.png (144.2 KiB) Viewed 5472 times
- Bed heater set to 60c, buildtak-covered glass installed
- FLIR0004.png (127 KiB) Viewed 5472 times
- Bed heater set to 60c, bare plate
- FLIR0003.png (133.64 KiB) Viewed 5472 times
Enjoy!