I am selling the main parts needed to make an enclosure for the M2.
I just sold my machine and didnt finish the enclosure before buyer wanted the machine alone.
You can see what it would look like here in one I made for my CR-10:
I am selling:
a quality cut, welded and drilled aluminum frame
the hinge hardware and magnetic push clasps
a mat heater, thermostat, and digital temperature controller.
You will need to buy plexiglass or glass for doors and wood for top and bottom and you are done!
$200 for the aluminum frame
$ 40 for the hardware
$ 35 for the heater
and invested much time developing parts and assembly.
I have it listed on ebay https://www.ebay.com/itm/Enclosure-kit- ... 3009124003
or am asking $300 OBO if you want to contact me directly.
The frame measures: 570mm H x 600 W x 500 L
A resource for used MakerGear equipment.
2 posts • Page 1 of 1