The place to discuss the M3-ID
- Posts: 11
- Joined: Fri Oct 30, 2015 3:35 pm
also best way to trouble shoot is to print a cylinder in vase mode and adjust the temperature on the fly. Start high then lower by 5 degrees until the bubbles disappear. bump your speed up to 1100mm/min (18mm/sec)
- Posts: 218
- Joined: Wed Jan 31, 2018 11:36 pm
Ok will give that a try when I have some time.
Have to wonder what changes were made in the filament drive housing between the M2 and M3..